our products

D&Q Mining is a high-tech company integrating R&D, production and sales. It provides mature products and solutions such as crushers, sand making, milling equipment, mobile crushing stations, etc., for aggregate, mining and waste recycling.

quarry dust as fine aggregate in concrete mixtures

Study on Performance of Quarry Dust as Fine Aggregate in

The suitability of quarry dust as alternative material for the river sand in concrete manufacturing is studied. M25 grade concrete was prepared with 0%, 20%, 40%, 60%, 80% partial replacement of...

More

Effect of Quarry Dust on High Performance Concrete

concrete mixtures. Usually, Quarry Rock Dust is used in large scale in the highways as a surface finishing material and also used for manufacturing of hollow blocks and lightweight concrete prefabricated Elements. Use of Quarry rock dust as a fine aggregate in concrete draws serious attention of researchers and investigators.

More

Utilization of Quarry Waste Fine Aggregate in Concrete

The overall test results revealed that quarry waste fine aggregate can be utilized in concrete mixtures as a good substitute of natural sand. Gradation of pit sand and quarry waste fine aggregate....

More

Analysis of Concrete Made from Quarry Dust

cement, fine aggregate, coarse aggregate, quarry dust. The examples were casted for M25 grade of concrete by supplanting the cement 0%, 5%, 10%, 15% and 20% by quarry dust and tested for workability by slump test, compressive strength, flexure strength and split tensile test at

More

Studies on Quarry Dust as Partial Replacement of Fine

1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

More

Studies on Quarry Dust as Partial Replacement of Fine

1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

More

Use of Quarry Dust to Replace Sand in Concrete An

Index Terms- Concrete, quarry dust, river sand, compressive strength. I. INTRODUCTION oncrete is the most widely used composite material today. The constituents of concrete are coarse aggregate, fine aggregate, binding material and water. Rapid increase in construction activities leads to

More

(PDF) Flowing Concretes with Quarry Waste Fine Aggregate

Quarry waste fine aggregate has been utilized to produce flowing concretes. In total, eight flowing concrete mixtures were prepared. Except for two control concretes, quarry waste fine aggregate

More

(PDF) Use of Quarry Dust to Replace Sand in Concrete An

The percentage of reduction in strength with respect to control concrete is 13.01 & 16.22 in M20 and M25 respectively.The above conclusion gives clear picture that quarry dust can be utilized in concrete mixtures as a good substitute for natural river sand with higher strength at 50% replacement.FigureFigure : 5.1 Compressive strength of

More

Introduction to Quarry-Dust as Partial Replacement

quarry dust as fine aggregate: effect on compressive strength,durability and workability of concrete. The experimental study done by R Chandana Sukesh, Katakam Bala Krishna, P.Sri Lakshmi Sai Teja, S.Kanakambara Rao.[6] in which replacement of the sand with quarry dust shows an improvement in the compressive strength of the concrete.

More

Properties of cold bonded quarry dust coarse aggregates

Sep 01, 2015 The quarry sand is the coarse fraction of the quarry powder and is being used as the fine aggregate in place of river sand in concrete production . The fine quarry dust fraction is commercially unused material . Therefore, utilization of waste material quarry dust in the production of artificial aggregates is examined in this study.

More

COMPARING THE COMPRESSIVE AND FLEXURAL STRENGTH

Abstract. This study tried to compare the flexural strength of concrete made with riversand and quarry dust as fine aggregate.River sand was collected from Osogbo, Osun State, replaced at 0-100% at intervals of 10% with quarry dust gotten from Wasimi, Osun State, Nigeria.Abstract Common river sand is expensive due to the excessive cost of transportation from natural sources.

More

Stone Dust in Concrete: Effect on Compressive Strength

or full replacement may be a promising alternative in concrete making. Quarry dust can be utilized in concrete mixtures as a good substitute for natural river sand giving higher strength at 50% replacement (Balamurgan et al., 2013). While using crushed stone dust as fine aggregate in concrete

More

[PDF] Use of Quarry Dust to Replace Sand in Concrete An

This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature. Also the temperature effect on concrete cubes at 100 o C on

More

A review on the utilisation of quarry and ornamental stone

Jan 15, 2016 They compared the conventional concrete with the concrete produced using quarry dust as fine aggregate, while replacing 10%, 15% and 20% of cement by fly ash. Slump values decrease with an increase in quarry dust. The decrease in workability by the addition of quarry dust is reduced by the addition of fly ash.

More

A Technical Review on Quarry Dust and Foundry Sand Used

using crushed stone dust as fine aggregate it is found that there is increase in compressive strength,flexural strength and tensile strength of concrete. Rafat Siddique, India (2009) [5]: has evaluated the mechanical properties of concrete mixtures in which fine aggregate partially replaced with used-foundry sand (UFS).

More

The Utilization of Quarry Dust as Fine Aggregates in

quarry dust, which is a waste product from quarry, as fine aggregates in traditional concrete. During the tenure of the study, some physical and engineering properties of quarry dust and sand were determined and compared. The compressive strength of concrete was determined after replacing sand with quarry dust in various ratios.

More

PARTIAL REPLACEMENT OF SAND BY QUARRY DUST IN

freshly mixed concrete. Since Quarry Dust is partially used as the fine aggregate, due to containing very fine particles it absorbs more water hence decreases the Workability. With use of some Superplasticizer this problem can be resolved. Result Table 1:- Slump value. Fine aggregate Slump (mm) Sand: Quarry dust M20 with w/c ratio 0.6 M25

More

Studies on quarry dust as partial replacement of fine

May 05, 2017 Studies on quarry dust as partial replacement of fine aggregates in concrete 1. International Journal of Latest Technology in Engineering, Management & Applied Science (IJLTEMAS) Volume VI, Issue IV, April 2017 ISSN 2278-2540 ijltemas.in Page 10 Studies on Quarry Dust as Partial Replacement of Fine Aggregates in Concrete Preethi A V1,Dr. S Rajendra2,Navneeth3,

More

The Utilization of Quarry Dust as Fine Aggregates in

quarry dust, which is a waste product from quarry, as fine aggregates in traditional concrete. During the tenure of the study, some physical and engineering properties of quarry dust and sand were determined and compared. The compressive strength of concrete was determined after replacing sand with quarry dust in various ratios.

More

Studies on Quarry Dust as Partial Replacement of Fine

1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

More

A Technical Review on Quarry Dust and Foundry Sand Used

using crushed stone dust as fine aggregate it is found that there is increase in compressive strength,flexural strength and tensile strength of concrete. Rafat Siddique, India (2009) [5]: has evaluated the mechanical properties of concrete mixtures in which fine aggregate partially replaced with used-foundry sand (UFS).

More

COMPARING THE COMPRESSIVE AND FLEXURAL STRENGTH

Abstract. This study tried to compare the flexural strength of concrete made with riversand and quarry dust as fine aggregate.River sand was collected from Osogbo, Osun State, replaced at 0-100% at intervals of 10% with quarry dust gotten from Wasimi, Osun State, Nigeria.Abstract Common river sand is expensive due to the excessive cost of transportation from natural sources.

More

Stone Dust in Concrete: Effect on Compressive Strength

or full replacement may be a promising alternative in concrete making. Quarry dust can be utilized in concrete mixtures as a good substitute for natural river sand giving higher strength at 50% replacement (Balamurgan et al., 2013). While using crushed stone dust as fine aggregate in concrete

More

Quarry Dust Uses in a Construction Project Concrete Blocks

Jun 06, 2016 The reduction in the sources of sand and the need to reduce the cost of construction projects has resulted in the increase need to identify alternative construction materials to sand as fine aggregates in the construction projects. Quarry dust a by- product from crushing process during quarrying activities is good alternative during construction projects. It is []

More

quarry waste in concrete .pdf

2017-2-2 Quarry Dust as full replacement in concrete as possible with proper treatment of Quarry Dust before utilization. Quarry waste fine aggregate was used in presence of silica fume. The overall test results revealed that quarry waste fine aggregate can be utilized in concrete mixtures as a good substitute of natural sand.

More

A review on the utilisation of quarry and ornamental stone

Jan 15, 2016 They compared the conventional concrete with the concrete produced using quarry dust as fine aggregate, while replacing 10%, 15% and 20% of cement by fly ash. Slump values decrease with an increase in quarry dust. The decrease in workability by the addition of quarry dust is reduced by the addition of fly ash.

More

characteristics of quarry dust BINQ Mining

Properties of green concrete containing quarry rock dust and marble sludge powder and quarry dust is used as fine Chemical characteristics of marble sludge powder, quarry rock dust, river sand and Portland cement. Evaluation of Soil-Quarry Dust Mixtures –

More

Martine

Quarry Dust As. Fine Aggregate in Concrete V- B time and compaction factor. f the Durability test of Quarry dust match up to the test results of regular. Stone crusher dust as a fine aggregate in Concrete for paving Some of the physical and mechanical properties of paving blocks with fine aggregate (sand) of quarry dust and

More

Experimental Investigation on Performance of Fly ash and

strength and transverse strength of mortar using quarry dust as fine aggregate. II LITERATURE REVIEW G. Balamurugan,Dr. P. Perumal, et al ( Nov, 2013) This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of

More

An Experimental Investigation on Properties of Concrete by

Dec 12, 2017 An Experimental Investigation on Properties of Concrete by Partial Replacement of Cement with GGBS and Fine Aggregate with Quarry Dust Dr. D. V. Prasada Rao, C. S. Mallikarjuna In the present study an investigation is made on properties of concrete by partial replacement of Cement with Ground Granulated Blast Furnace Slag (GGBS) and Fine

More

Strength and Corrosion Resistance Properties of Ggbs

Concrete Containing Quarry Dust as Fine Aggregate, 2008. [4] Joel Manasseh, Have Investigated the Suitability of Crushed Granite Fines to Replace River Sand in Concrete Production for Rigid Pavement, 2010. [5] Murugesan et al., Examined the Effect of Super Plasticizer in Quarry Dust replaced Concrete, 2006. Radhikesh et al

More

QUESTION 1.edited.docx QUESTION 1 Partial Replacement of

QUARRY DUST The major constituents of Concrete are coarse aggregate, fine aggregate, cement and water. The function of the fine aggregate is to assist in producing workability and uniformity in the mixture. It is conventional that Sand is being used as fine aggregate in Concrete.

More